User Tools
wiki:en:2dcam:faq
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:en:2dcam:faq [2017/01/24 11:42] admin |
wiki:en:2dcam:faq [2018/02/07 19:24] (current) |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| **Is this a full CAD-program? | **Is this a full CAD-program? | ||
| - | //No, nor is it intended to be either. It uses Lines, Circles (not arcs) and Points. That's it.// | + | //No, nor is it intended to be. It uses Lines, Circles (not arcs) and Points. That's it.// |
| **How advanced is the pocket-milling cycle?** | **How advanced is the pocket-milling cycle?** | ||
| //It is basic. It only supports lines as a contour and not too complicated contours.// | //It is basic. It only supports lines as a contour and not too complicated contours.// | ||
| + | |||
| + | **Can I import a DXF/DWG file?** | ||
| + | |||
| + | //Yes, depending on version of DXF/DWG file// | ||
| **What happens to the license if the computer fails and a new computer is used?** | **What happens to the license if the computer fails and a new computer is used?** | ||
wiki/en/2dcam/faq.1485254555.txt.gz · Last modified: 2018/02/07 19:23 (external edit)
Page Tools
