Differences

This shows you the differences between two versions of the page.

--- wiki:en:2dcam:ncdatafliken [2017/01/24 10:51]
admin
+++ — (current)
@@ Line 1: / Line 1: @@
-====== NC-Data tab ======
-{{wiki:en:2dcam:ncdatatab.png?nolink&700|}}
-===== Description =====
-The NC-Data tab contains functions for creating tool-paths
-===== Funcitons =====
-[[sv:trigfix:mnuNCpoint|Coordinate point]] |
-[[wiki:en:2dcam:mnuNCG0|Rapid (G0)]] |
-[[sv:trigfix:mnuNCG1|Feed (G1)]] |
-[[sv:trigfix:mnuNCG23|Circular (G2/3)]] |
-[[sv:trigfix:mnuNCAbs|Absolute values]] |
-[[sv:trigfix:mnuNCtext|Manual]] |
-[[sv:trigfix:mnuGFollow|Follow contour]] |
-[[sv:trigfix:mnuNCRPocket|Rectangular pocket]] |
-[[sv:trigfix:mnuNCCPocket|Circular pocket]] |
-[[sv:trigfix:mnuNCTRough|Roughing cycle turn]] |
-[[sv:trigfix:mnuNCFRough|Roughing cycle face]] |
-[[sv:trigfix:mnuNCRepeat|Roughing cycle repeat]] |
-[[sv:trigfix:mnuNCClear|Clear operations]]
-===== See also =====
-[[sv:trigfix:starttab|Start tab]] |
-[[sv:trigfix:circletab|Circular tab]] |
-[[sv:trigfix:linetab|Linear tab]] |
-[[sv:trigfix:pointtab|Point tab]] |
-[[sv:trigfix:modifytab|Modify tab]] |
-[[sv:trigfix:viewtab|View tab]]

MicroTech StellaData AB