Table of Contents
Quickstart guide
First you need to setup MazView to work with your machine.
Settings
The Communication Tab
- Set the correct COM-port, Baud-rate and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
The Paths Tab
- Set the path to your existing Mazak files (if any).
Press Save and Close
Communication
To send a mazatrol program from the Machine to the Computer do the following:
- Select the folder where you want to store the program
- Press Receive button on the Start tab
- At the machine: Start the transmission and wait until it's done.
- At the computer: Press Close
- Enter optional comment and filename (the filename should be suggested)
To send a mazatrol program from the Computer to the Machine do the following:
- Select the folder where the program you want to send is located.
- Select the program in the filelist
- Press the Send button on the Start tab
- At the machine: Enter the program-number and start the receive. Wait until the transmission is done
- At the computer: Press Close
Preview of program
- Select the folder where the program you want to view is located.
- Select the program in the filelist
- Press the Preview button on the Start tab
- A preview window will appear with the program in it.
