This shows you the differences between two versions of the page.
wiki:en:2dcam:faq [2017/01/24 11:42] admin |
wiki:en:2dcam:faq [2018/02/07 19:24] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Frequently asked questions ====== | ||
- | |||
- | **Is this a full CAD-program? | ||
- | |||
- | //No, nor is it intended to be either. It uses Lines, Circles (not arcs) and Points. That's it.// | ||
- | |||
- | **How advanced is the pocket-milling cycle?** | ||
- | |||
- | //It is basic. It only supports lines as a contour and not too complicated contours.// | ||
- | |||
- | **What happens to the license if the computer fails and a new computer is used?** | ||
- | |||
- | //You can reactivate your license with the original e-mail and key.// | ||
- | |||
- | |||