This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
wiki:en:2dcam:faq [2017/01/24 11:41] admin created |
wiki:en:2dcam:faq [2018/02/07 19:24] (current) |
||
---|---|---|---|
Line 3: | Line 3: | ||
**Is this a full CAD-program? | **Is this a full CAD-program? | ||
- | //No, nor is it intended to be either. It uses Lines, Circles (not arcs) and Points. That's it.// | + | //No, nor is it intended to be. It uses Lines, Circles (not arcs) and Points. That's it.// |
**How advanced is the pocket-milling cycle?** | **How advanced is the pocket-milling cycle?** | ||
Line 9: | Line 9: | ||
//It is basic. It only supports lines as a contour and not too complicated contours.// | //It is basic. It only supports lines as a contour and not too complicated contours.// | ||
+ | **Can I import a DXF/DWG file?** | ||
+ | |||
+ | //Yes, depending on version of DXF/DWG file// | ||
+ | |||
+ | **What happens to the license if the computer fails and a new computer is used?** | ||
+ | |||
+ | //You can reactivate your license with the original e-mail and key.// | ||