User Tools

Site Tools


wiki:en:2dcam:faq

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
wiki:en:2dcam:faq [2017/01/24 11:42]
admin
wiki:en:2dcam:faq [2018/02/07 19:24] (current)
Line 3: Line 3:
 **Is this a full CAD-program?​** **Is this a full CAD-program?​**
  
-//No, nor is it intended to be either. It uses Lines, Circles (not arcs) and Points. That's it.//+//No, nor is it intended to be. It uses Lines, Circles (not arcs) and Points. That's it.//
  
 **How advanced is the pocket-milling cycle?** **How advanced is the pocket-milling cycle?**
  
 //It is basic. It only supports lines as a contour and not too complicated contours.// //It is basic. It only supports lines as a contour and not too complicated contours.//
 +
 +**Can I import a DXF/DWG file?**
 +
 +//Yes, depending on version of DXF/DWG file//
  
 **What happens to the license if the computer fails and a new computer is used?** **What happens to the license if the computer fails and a new computer is used?**
wiki/en/2dcam/faq.txt · Last modified: 2018/02/07 19:24 (external edit)