This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:en:mazview:machines:readcmt [2018/01/15 08:51] admin |
wiki:en:mazview:machines:readcmt [2018/01/15 11:12] admin |
||
---|---|---|---|
Line 8: | Line 8: | ||
* Start MazView | * Start MazView | ||
* Click on the Mazak Disk tab | * Click on the Mazak Disk tab | ||
+ | {{: | ||
* If the disk that has been used has two square holes on it, you might need to tape the one that is on the right | * If the disk that has been used has two square holes on it, you might need to tape the one that is on the right | ||
{{: | {{: | ||
Line 13: | Line 14: | ||
* Click Import Mazak Disk | * Click Import Mazak Disk | ||
* Select the type of machine (T1 & T4 are a little different so usually it's " | * Select the type of machine (T1 & T4 are a little different so usually it's " | ||
- | | + | {{: |
- | * | + | |
+ | {{: | ||
+ | * Select where you want the read files to be located. The files will be numbered and the number will be added ti the filename you specify. | ||
+ | {{: | ||
+ | |||
+ | The files will show up in MazView as .MAZ files | ||
+ | |||
+ | {{: |