User Tools
wiki:en:mazview:quickstart
Differences
This shows you the differences between two versions of the page.
|
wiki:en:mazview:quickstart [2014/03/17 15:18] admin |
wiki:en:mazview:quickstart [2018/02/07 19:24] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Quickstart guide ====== | ||
| - | |||
| - | First you need to setup MazView to work with your machine.\\ | ||
| - | |||
| - | ===== Settings ===== | ||
| - | |||
| - | * On the [[wiki: | ||
| - | ==== The Communication Tab ==== | ||
| - | * Set the correct COM-port, Baud-rate and Control so it matches your machine. Baud-rate 4800 is a typical default speed. | ||
| - | |||
| - | ==== The Paths Tab ==== | ||
| - | * Set the path to your existing Mazak files (if any). | ||
| - | |||
| - | Press Save and Close | ||
| - | |||
| - | ===== Communication ===== | ||
| - | |||
| - | ==== To send a mazatrol program **from the Machine to the Computer** do the following: | ||
| - | * Select the folder where you want to store the program | ||
| - | * Press Receive button on the Start tab | ||
| - | * At the machine: Start the transmission and wait until it's done. | ||
| - | * At the computer: Press Close | ||
| - | * Enter optional comment and filename (the filename should be suggested) | ||
| - | |||
| - | ==== To send a mazatrol program **from the Computer to the Machine** do the following: | ||
| - | * Select the folder where the program you want to send is located. | ||
| - | * Select the program in the filelist | ||
| - | * Press Send on the Start tab | ||
| - | * At the machine: Enter the program-number and start the receive. Wait until the transmission is done | ||
| - | * At the computer: Press Close | ||
| - | |||
wiki/en/mazview/quickstart.txt · Last modified: 2018/02/07 19:24 (external edit)
Page Tools
