This shows you the differences between two versions of the page.
wiki:en:mazview:quickstart [2014/03/17 15:30] admin |
wiki:en:mazview:quickstart [2018/02/07 19:24] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Quickstart guide ====== | ||
- | |||
- | First you need to setup MazView to work with your machine.\\ | ||
- | |||
- | ===== Settings ===== | ||
- | |||
- | * On the [[wiki: | ||
- | ==== The Communication Tab ==== | ||
- | * Set the correct COM-port, [[wiki: | ||
- | |||
- | ==== The Paths Tab ==== | ||
- | * Set the path to your existing Mazak files (if any). | ||
- | |||
- | Press Save and Close | ||
- | |||
- | ===== Communication ===== | ||
- | |||
- | ==== To send a mazatrol program **from the Machine to the Computer** do the following: | ||
- | * Select the folder where you want to store the program | ||
- | * Press [[wiki: | ||
- | * At the machine: Start the transmission and wait until it's done. | ||
- | * At the computer: Press Close | ||
- | * Enter optional comment and filename (the filename should be suggested) | ||
- | |||
- | ==== To send a mazatrol program **from the Computer to the Machine** do the following: | ||
- | * Select the folder where the program you want to send is located. | ||
- | * Select the program in the filelist | ||
- | * Press the [[wiki: | ||
- | * At the machine: Enter the program-number and start the receive. Wait until the transmission is done | ||
- | * At the computer: Press Close | ||
- | |||