Differences

This shows you the differences between two versions of the page.

--- wiki:en:mazview:machines:readcmt [2018/01/15 08:51]
admin
+++ wiki:en:mazview:machines:readcmt [2018/02/07 19:24] (current)
@@ Line 8: / Line 8: @@
   * Start MazView
   * Click on the Mazak Disk tab
+{{:wiki:en:mazview:machines:cmt:cmttab.png|}}
   * If the disk that has been used has two square holes on it, you might need to tape the one that is on the right
   {{:wiki:en:mazview:machines:cmt:cmtdisk1.png|}}
@@ Line 13: / Line 14: @@
   * Click Import Mazak Disk
   * Select the type of machine (T1 & T4 are a little different so usually it's "Övriga") and Click OK
-  * Wait until the Disk has been read successfully
+{{:wiki:en:mazview:machines:cmt:cmtwindow.png|}}
-  *
+  * Wait until the Disk has been read successfully and press OK
+{{:wiki:en:mazview:machines:cmt:diskimport2.png|}}
+  * Select where you want the read files to be located. The files will be numbered and the number will be added ti the filename you specify.
+{{:wiki:en:mazview:machines:cmt:diskimport.png|}}
+The files will show up in MazView as .MAZ files
+{{:wiki:en:mazview:machines:cmt:diskimportc.png|}}
+* Done!

MicroTech StellaData AB