Differences

This shows you the differences between two versions of the page.

--- wiki:en:mazview:quickstart [2014/03/17 15:34]
admin
+++ wiki:en:mazview:quickstart [2018/02/07 19:24] (current)
@@ Line 5: / Line 5: @@
 ===== Settings =====
-  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section
+  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:settings|Settings]] in the Machines section
 ==== The Communication Tab ====
   * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
@@ Line 16: / Line 16: @@
 ===== Communication =====
-==== To send a mazatrol program **from the Machine to the Computer** do the following:\\ ====
+==== To send a mazatrol program from the Machine to the Computer do the following: ====
   * Select the folder where you want to store the program
   * Press [[wiki:en:mazview:ReceiveButton|Receive button]] on the [[wiki:en:mazview:starttab|Start tab]]
@@ Line 23: / Line 23: @@
   * Enter optional comment and filename (the filename should be suggested)
-==== To send a mazatrol program **from the Computer to the Machine** do the following:\\ ====
+==== To send a mazatrol program from the Computer to the Machine do the following: ====
   * Select the folder where the program you want to send is located.
   * Select the program in the filelist
@@ Line 30: / Line 30: @@
   * At the computer: Press Close
-====== Preview of program ======
+===== Preview of program =====
   * Select the folder where the program you want to view is located.
   * Select the program in the filelist
   * Press the [[wiki:en:mazview:PreviewButton|Preview button]] on the Start tab
   * A preview window will appear with the program in it.
+{{:wiki:en:mazview:previewwindow.png?nolink|}}

MicroTech StellaData AB

User Tools

Site Tools

Differences

Page Tools