MicroTech StellaData AB

User Tools

Site Tools

You are here: start » wiki » en » mazview » quickstart
wiki:en:mazview:quickstart

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
wiki:en:mazview:quickstart [2014/03/17 16:11]
admin [To send a mazatrol program **from the Computer to the Machine** do the following:\\] 		wiki:en:mazview:quickstart [2018/02/07 19:24] (current)
Line 5: Line 5:
 ===== Settings ===== ===== Settings =====
  
-  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section+  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:settings|Settings]] in the Machines section
 ==== The Communication Tab ==== ==== The Communication Tab ====
   * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.   * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
wiki/en/mazview/quickstart.txt · Last modified: 2018/02/07 19:24 (external edit)

Page Tools

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki