Differences

This shows you the differences between two versions of the page.

--- wiki:en:mazview:quickstart [2014/03/17 15:29]
admin
+++ wiki:en:mazview:quickstart [2014/03/17 15:39]
admin
@@ Line 7: / Line 7: @@
   * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section
 ==== The Communication Tab ====
-  * Set the correct COM-port, Baud-rate and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
+  * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
 ==== The Paths Tab ====
@@ Line 30: / Line 30: @@
   * At the computer: Press Close
+===== Preview of program =====
+  * Select the folder where the program you want to view is located.
+  * Select the program in the filelist
+  * Press the [[wiki:en:mazview:PreviewButton|Preview button]] on the Start tab
+  * A preview window will appear with the program in it.
+{{:wiki:en:mazview:previewwindow.png?nolink|}}

MicroTech StellaData AB