User Tools

Site Tools


wiki:en:mazview:quickstart

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
wiki:en:mazview:quickstart [2014/03/17 16:10]
admin [To send a mazatrol program **from the Machine to the Computer** do the following:\\]
wiki:en:mazview:quickstart [2016/12/21 12:25]
admin [Settings]
Line 5: Line 5:
 ===== Settings ===== ===== Settings =====
  
-  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section+  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:settings|Settings]] in the Machines section
 ==== The Communication Tab ==== ==== The Communication Tab ====
   * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.   * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
Line 23: Line 23:
   * Enter optional comment and filename (the filename should be suggested)   * Enter optional comment and filename (the filename should be suggested)
  
-==== To send a mazatrol program **from the Computer to the Machine** do the following:\\ ====+==== To send a mazatrol program from the Computer to the Machine do the following: ====
   * Select the folder where the program you want to send is located.   * Select the folder where the program you want to send is located.
   * Select the program in the filelist   * Select the program in the filelist
wiki/en/mazview/quickstart.txt · Last modified: 2018/02/07 19:24 (external edit)