This shows you the differences between two versions of the page.
wiki:en:mazview:quickstart [2014/03/17 16:11] admin [To send a mazatrol program **from the Computer to the Machine** do the following:\\] |
wiki:en:mazview:quickstart [2018/02/07 19:24] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Quickstart guide ====== | ||
- | First you need to setup MazView to work with your machine.\\ | ||
- | |||
- | ===== Settings ===== | ||
- | |||
- | * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section | ||
- | ==== The Communication Tab ==== | ||
- | * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed. | ||
- | |||
- | ==== The Paths Tab ==== | ||
- | * Set the path to your existing Mazak files (if any). | ||
- | |||
- | Press Save and Close | ||
- | |||
- | ===== Communication ===== | ||
- | |||
- | ==== To send a mazatrol program from the Machine to the Computer do the following: ==== | ||
- | * Select the folder where you want to store the program | ||
- | * Press [[wiki:en:mazview:ReceiveButton|Receive button]] on the [[wiki:en:mazview:starttab|Start tab]] | ||
- | * At the machine: Start the transmission and wait until it's done. | ||
- | * At the computer: Press Close | ||
- | * Enter optional comment and filename (the filename should be suggested) | ||
- | |||
- | ==== To send a mazatrol program from the Computer to the Machine do the following: ==== | ||
- | * Select the folder where the program you want to send is located. | ||
- | * Select the program in the filelist | ||
- | * Press the [[wiki:en:mazview:SendButton|Send button]] on the [[wiki:en:mazview:starttab|Start tab]] | ||
- | * At the machine: Enter the program-number and start the receive. Wait until the transmission is done | ||
- | * At the computer: Press Close | ||
- | |||
- | ===== Preview of program ===== | ||
- | * Select the folder where the program you want to view is located. | ||
- | * Select the program in the filelist | ||
- | * Press the [[wiki:en:mazview:PreviewButton|Preview button]] on the Start tab | ||
- | * A preview window will appear with the program in it. | ||
- | {{:wiki:en:mazview:previewwindow.png?nolink|}} |