This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:en:mazview:quickstart [2014/03/17 15:12] admin |
wiki:en:mazview:quickstart [2018/02/07 19:24] (current) |
||
---|---|---|---|
Line 5: | Line 5: | ||
===== Settings ===== | ===== Settings ===== | ||
- | * On the [[wiki: | + | * On the [[wiki: |
==== The Communication Tab ==== | ==== The Communication Tab ==== | ||
- | * Set the correct COM-port, Baud-rate and Control so it matches your machine. Baud-rate 4800 is a typical default speed. | + | * Set the correct COM-port, |
==== The Paths Tab ==== | ==== The Paths Tab ==== | ||
Line 13: | Line 13: | ||
Press Save and Close | Press Save and Close | ||
+ | |||
+ | ===== Communication ===== | ||
+ | |||
+ | ==== To send a mazatrol program from the Machine to the Computer do the following: ==== | ||
+ | * Select the folder where you want to store the program | ||
+ | * Press [[wiki: | ||
+ | * At the machine: Start the transmission and wait until it's done. | ||
+ | * At the computer: Press Close | ||
+ | * Enter optional comment and filename (the filename should be suggested) | ||
+ | |||
+ | ==== To send a mazatrol program from the Computer to the Machine do the following: ==== | ||
+ | * Select the folder where the program you want to send is located. | ||
+ | * Select the program in the filelist | ||
+ | * Press the [[wiki: | ||
+ | * At the machine: Enter the program-number and start the receive. Wait until the transmission is done | ||
+ | * At the computer: Press Close | ||
+ | |||
+ | ===== Preview of program ===== | ||
+ | * Select the folder where the program you want to view is located. | ||
+ | * Select the program in the filelist | ||
+ | * Press the [[wiki: | ||
+ | * A preview window will appear with the program in it. | ||
+ | {{: |