This is an old revision of the document!
Quickstart guide
First you need to setup MazView to work with your machine.
Settings
The Communication Tab
The Paths Tab
Communication
To send a mazatrol program **from the Machine to the Computer** do the following:\\
Select the folder where you want to store the program
Press Receive button on the Start tab
At the machine: Start the transmission and wait until it's done.
At the computer: Press Close
Enter optional comment and filename (the filename should be suggested)
To send a mazatrol program **from the Computer to the Machine** do the following:\\
Select the folder where the program you want to send is located.
Select the program in the filelist
Press Send on the Start tab
At the machine: Enter the program-number and start the receive. Wait until the transmission is done
At the computer: Press Close