User Tools

Site Tools


wiki:en:mazview:quickstart

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
wiki:en:mazview:quickstart [2014/03/17 15:18]
admin
wiki:en:mazview:quickstart [2018/02/07 19:24] (current)
Line 5: Line 5:
 ===== Settings ===== ===== Settings =====
  
-  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:CNCSettings|Settings]] in the Machines section+  * On the [[wiki:en:mazview:StartTab|Start tab]], Press [[wiki:en:mazview:settings|Settings]] in the Machines section
 ==== The Communication Tab ==== ==== The Communication Tab ====
-  * Set the correct COM-port, Baud-rate and Control so it matches your machine. Baud-rate 4800 is a typical default speed.+  * Set the correct COM-port, [[wiki:en:mazview:BaudrateParameters|Baud-rate]] and Control so it matches your machine. Baud-rate 4800 is a typical default speed.
  
 ==== The Paths Tab ==== ==== The Paths Tab ====
Line 16: Line 16:
 ===== Communication ===== ===== Communication =====
  
-==== To send a mazatrol program **from the Machine to the Computer** do the following:\\ ====+==== To send a mazatrol program from the Machine to the Computer do the following: ====
   * Select the folder where you want to store the program   * Select the folder where you want to store the program
-  * Press Receive button on the Start tab+  * Press [[wiki:en:mazview:ReceiveButton|Receive button]] on the [[wiki:en:mazview:starttab|Start tab]]
   * At the machine: Start the transmission and wait until it's done.   * At the machine: Start the transmission and wait until it's done.
   * At the computer: Press Close   * At the computer: Press Close
   * Enter optional comment and filename (the filename should be suggested)   * Enter optional comment and filename (the filename should be suggested)
  
-==== To send a mazatrol program **from the Computer to the Machine** do the following:\\ ====+==== To send a mazatrol program from the Computer to the Machine do the following: ====
   * Select the folder where the program you want to send is located.   * Select the folder where the program you want to send is located.
   * Select the program in the filelist   * Select the program in the filelist
-  * Press Send on the Start tab+  * Press the [[wiki:en:mazview:SendButton|Send button]] on the [[wiki:en:mazview:starttab|Start tab]]
   * At the machine: Enter the program-number and start the receive. Wait until the transmission is done   * At the machine: Enter the program-number and start the receive. Wait until the transmission is done
   * At the computer: Press Close   * At the computer: Press Close
  
 +===== Preview of program ===== 
 +  * Select the folder where the program you want to view is located. 
 +  * Select the program in the filelist 
 +  * Press the [[wiki:en:mazview:PreviewButton|Preview button]] on the Start tab 
 +  * A preview window will appear with the program in it. 
 +{{:wiki:en:mazview:previewwindow.png?nolink|}}
wiki/en/mazview/quickstart.1395065896.txt.gz · Last modified: 2018/02/07 19:23 (external edit)