User Tools
wiki:en:2dcam:quickstart
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:en:2dcam:quickstart [2017/01/24 10:04] admin |
wiki:en:2dcam:quickstart [2018/02/07 19:24] (current) |
||
|---|---|---|---|
| Line 113: | Line 113: | ||
| Now we're going to create NC-code around the outer square. Do like this: | Now we're going to create NC-code around the outer square. Do like this: | ||
| - | * Click on the [[wiki: | + | * Click on the [[wiki: |
| * Click on the [[wiki: | * Click on the [[wiki: | ||
| * Click on the point that we drew as our start-point (X110 Y50). The point should be marked Red and if you move the mouse, a red line will follow the mouse pointer. | * Click on the point that we drew as our start-point (X110 Y50). The point should be marked Red and if you move the mouse, a red line will follow the mouse pointer. | ||
| Line 136: | Line 136: | ||
| To look at the NC-code, do like this: | To look at the NC-code, do like this: | ||
| - | * Click on the [[wiki: | + | * Click on the [[wiki: |
| * Click on the [[wiki: | * Click on the [[wiki: | ||
| Line 149: | Line 149: | ||
| We already are at a good starting point for our tool-path so we just continue as with the last square. | We already are at a good starting point for our tool-path so we just continue as with the last square. | ||
| - | * Click on the [[wiki: | + | * Click on the [[wiki: |
| * Click on the [[wiki: | * Click on the [[wiki: | ||
| * Click on mid-point (Magenta) on the horizontal line that makes up an edge of the square. | * Click on mid-point (Magenta) on the horizontal line that makes up an edge of the square. | ||
| Line 167: | Line 167: | ||
| First let's move with parid to the center of the circle: | First let's move with parid to the center of the circle: | ||
| - | * Click on the [[wiki: | + | * Click on the [[wiki: |
| * Click on the [[wiki: | * Click on the [[wiki: | ||
| * Click on the Center-point (Orange) of the circle (X50 Y50) | * Click on the Center-point (Orange) of the circle (X50 Y50) | ||
| Line 189: | Line 189: | ||
| And to look at the NC-code, do like before: | And to look at the NC-code, do like before: | ||
| - | * Click on the [[wiki: | + | * Click on the [[wiki: |
| * Click on the [[wiki: | * Click on the [[wiki: | ||
wiki/en/2dcam/quickstart.1485248644.txt.gz · Last modified: 2018/02/07 19:23 (external edit)
Page Tools
